Arduino 2.4"TFT LCD Touch Shield w/ILI9341.Library for Mega/Due/Uno

Description

Spice up your Arduino project with a beautiful touchscreen display shield with built in microSD card connection. This TFT display is 2.4" diagonal and colorful (18-bit 262,000 different shades)! 240x320 pixels with individual pixel control. As a bonus, this display has a optional capacitive touch panel and resistive touch panel with controller XPT2046 attached by default.

The shield is fully assembled, tested and ready to go. No wiring, no soldering! Simply plug it in and load up our library - you'll have it running in under 10 minutes! Works best with any classic Arduino (UNO/Due/Mega 2560).
This display shield has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. You can connect more sensors, buttons and LEDs.

Of course, we wouldn't just leave you with a datasheet and a "good luck!" - we've written a full open source graphics library at the bottom of this page that can draw pixels, lines, rectangles, circles and text. We also have a touch screen library that detects x,y and z (pressure) and example code to demonstrate all of it. The code is written for Arduino but can be easily ported to your favorite microcontroller!

For people who want the same screen but not in a shield, check out our 2.4" TFT breakout.

What's included in the package ?

Number	Standard Accessory Name	Quantity
1	2.4 inch TFT LCD Display with ILI9341 Controller and Breakout Board	1
2	Arduino Shield	1

*The default power supply is 5V and the default interface is 4-wire serial interface. 

 

Compatible with following Arduino Boards

Board Name	MCU	I/O
Arduino MEGA2560	ATMEGA2560	54
Arduino MEGA1280	ATMEGA1280	54
Arduino Due	AT91SAM3X8EA	54
Arduino Uno	ATMEGA328	14

 

Attention

If you've had a lot of Arduino DUEs go through your hands (or if you are just unlucky), chances are you’ve come across at least one that does not start-up properly.The symptom is simple: you power up the Arduino but it doesn’t appear to “boot”. Your code simply doesn't start running.You might have noticed that resetting the board (by pressing the reset button) causes the board to start-up normally.The fix is simple,here is the solution.

 

Datasheet for Display Module

Format	Documents Name	Language	Update Date	Size
	ER-TFTM024-3 Datasheet	English	Mar-22-2022	1.9M
	Controller ILI9341 Datasheet	English	Jul-02-2013	3.2M

 

Datasheet and Schematic for Arduino Shield

Format	Documents Name	Language	Update Date	Size
	ER-AS-ILI9341 Datasheet	English	Feb-24-2016	828K
	ER-AS-ILI9341 Arduino Schematic Diagram	English	Oct-16-2018	192K

 

Tutorial - Arduino Due (MEGA 2560,Uno)Libraries,Examples

Format	Documents Name	Language	Update Date	Size
	Arduino Library and Example	English	Mar-25-2022	763K